Guida Vasca Idromassaggio

Fill → turn on → choose a function.

First: follow these 2 steps 👇

Take it slow and follow the order. Then choose the function you want to use.

1) Fill the tub

Hot water + LEDs covered

Turn on the tap and set your preferred temperature (use the knobs).
Fill until the LED lights are covered.

IMPORTANT: the gray suction cup must stay over the drain.

2) Turn on the display

Only after filling the tub

To turn on the hot tub, press the ON button.

If an icon is flashing = low water level → add more hot water.

Watch video ON/OFF panel

Now choose a function 👇

You’ve already filled the tub and turned on the display.

If the display doesn’t respond: it’s in energy-saving mode → press the lock/FUN button to unlock it.

Water jets

Stronger massage

Press the first button (Water Pump).
To turn it off, press the first button again.

Watch video Water pump

Bubbles (air jets)

Softer massage

Press the second button (Air Pump) to turn the jets on.
Once active, press Fun/🔓 until the intensity indicator appears on the display.
Use the arrows to set the intensity from 1 to 10.

Watch video Air pump

Chromotherapy

Color therapy

Press the third button (Sun icon).
Press it again to change the color sequence.

Watch video Lights

Thermostat

Maintains temperature (doesn’t heat)

Important: the thermostat DOES NOT heat the water.
Hot water comes from the tap.
It only maintains the temperature during your bath.

Press the first button (Water Pump).
Then press the C° button (Thermostat).
Once it’s on, press Fun/🔒 until the temperature icon appears on the display.
Use the arrows to adjust the temperature.

Note: if the temperature icon (C°) under the degrees is flashing, the water level is too low.
👉 Add hot water until it covers the LED lights.

If the water is cold → add hot water from the tap.
The thermostat cannot heat cold water.

Watch video Water pump (for thermostat)